DAP-1360U Wireless N300 Access Point & Router
User Manual
Installation and Connection
PC with Wi-Fi Adapter
1. Attach the antennas from the delivery package. To do this, remove the antennas from their
wrapper, attach them to the relevant connectors on the back panel of the access point, and
then screw the antennas in a clockwise direction to the back panel. Position the antennas
upward at their connecting joints. This will ensure optimal operation of your wireless
network.
2. Connect the power cord to the power connector port on the back panel of the access point,
then plug the power adapter into an electrical outlet or power strip.
3. Turn on the access point by pressing the ON/OFF button on its back panel.
4. Make sure that the Wi-Fi adapter of your PC is on. As a rule, modern notebooks with built-
in wireless NICs are equipped with a button or switch that turns on/off the wireless adapter
(refer to your PC documents). If your PC is equipped with a pluggable wireless NIC, install
the software provided with your Wi-Fi adapter.
Now you should configure your Wi-Fi adapter.
Page 19 of 158
To Next Page
Loading...
