DAP-1360U Wireless N300 Access Point & Router
User Manual
Configuring via Web-based Interface
Client
This page is available for the Router, Access point, WISP Repeater, Repeater, and Client
modes.
On the Wi-Fi / Client page, you can configure the device as a client to connect to a wireless access
point or to a WISP.
Figure 79. The page for configuring the client mode.
To configure the access point as a client, move the Enable switch to the right. Upon that the
following fields are displayed on the page:
Parameter Description
Broadcast wireless
network 2.4 GHz
If the switch is moved to the left, devices cannot connect to the
access point's WLAN. Upon that the access point can connect to
another access point as a wireless client.
Connecting to network
A method for connecting to another access point.
Page 97 of 158
To Next Page
Loading...
