DAP-1360U Wireless N300 Access Point & Router
User Manual
Configuring via Web-based Interface
Conguring Wireless Network
This configuration step is available for the Router, Access point, WISP Repeater, Repeater,
and WDS modes.
1. On the Wireless Network 2.4 GHz page, in the Network name field, specify your own
name for the wireless network or leave the value suggested by the access point.
2. In the Password field, specify your own password for access to the wireless network or
leave the value suggested by the access point (WPS PIN of the device, see the barcode
label).
3. If the access point is used as a Wi-Fi client, you can specify the same parameters of the
wireless network as specified for the network to which you are connecting. To do this, click
the USE button (available for the Repeater mode only).
4. You can restore the parameters of the wireless network specified before resetting to factory
defaults. To do this, click the RESTORE button.
Figure 37. The page for configuring the wireless network.
Page 45 of 158
To Next Page
Loading...
