DAP-1360U Wireless N300 Access Point & Router
User Manual
Configuring via Web-based Interface
Remote Update
!
Attention! Do not turn off the access point before the firmware update is completed. This
may cause the device breakdown.
To update the firmware of the access point remotely, follow the next steps:
1. On the System / Firmware Update page, in the Remote Update section, click the
CHECK FOR UPDATES button to check if a newer firmware version exists.
2. Click the UPDATE FIRMWARE button (the button is displayed if a newer version of the
firmware is available).
3. Wait until the access point is rebooted (about one and a half or two minutes).
4. Log into the web-based interface using the login (admin) and the current password.
If after updating the firmware the access point doesn't work correctly, please restore the factory
default settings. To do this, click the Factory button on the System / Configuration page. Wait
until the access point is rebooted.
Page 145 of 158
To Next Page
Loading...
