D-Link DAP-1360U

DAP-1360U Wireless N300 Access Point & Router
User Manual
Configuring via Web-based Interface
Conguration
On the System / Configuration page, you can change the password for the administrator account
used to access the web-based interface of the access point and to access the device settings via
TELNET, restore the factory defaults, backup the current configuration, restore the access point's
configuration from a previously created file, save the changed settings to the non-volatile memory,
reboot the device, or change the web-based interface language.
Figure 111. The System / Configuration page.
In order to change the password for the administrator account, in the User section, enter a new
password in the New password and Password confirmation fields. Use digits, Latin letters
(uppercase and/or lowercase), and other characters available in the US keyboard layout.
4
Click the
Show icon ( ) to display the entered values. Then click the SAVE button.
!
Remember or write down the new password for the administrator account. In case of losing
the new password, you can access the settings of the access point only after restoring the
factory default settings via the hardware RESET button. This procedure wipes out all
settings that you have configured for your access point .
To change the web-based interface language, select the needed value from the Language drop-
down list.
4 0-9, A-Z, a-z, space, !"#$%&'()*+,-./:;<=>?@[\]^_`{|}~.
Page 141 of 158