DAP-1360U Wireless N300 Access Point & Router
User Manual
Configuring via Web-based Interface
CHAPTER 4. CONFIGURING VIA WEB-BASED
INTERFACE
Initial Configuration Wizard
To start the Initial Configuration Wizard, go to the Initial Configuration section. On the opened
page, click the OK button and wait until the factory default settings are restored.
Figure 18. Restoring the default settings in the Wizard.
If you perform initial configuration of the access point via Wi-Fi connection, please make sure that
you are connected to the wireless network of DAP-1360U (see the WLAN name (SSID) on the
barcode label on the bottom panel of the device) and click the NEXT button.
Figure 19. Checking connection to the wireless network.
Click the START button.
Figure 20. Starting the Wizard.
Page 30 of 158
To Next Page
Loading...
