D-Link DAP-1360U

DAP-1360U Wireless N300 Access Point & Router
User Manual
Configuring via Web-based Interface
In the opened window, you can specify the following parameters:
Parameter Description
Interface
From the drop-down list, select an interface through which the
destination network can be accessed. If you have selected the Auto
value, the access point itself sets the interface on the basis of data on
connected networks.
Destination network
A destination network to which this route is assigned.
Destination netmask The destination network mask.
Gateway
An IP address through which the destination network can be accessed.
Metric
A metric for the route. The lower the value, the higher is the route
priority. Optional.
After specifying the needed parameters, click the SAVE button.
To edit an existing route, select a relevant line of the table. In the opened window, change the
needed parameters and click the SAVE button.
To remove an existing route, select the checkbox located to the left of the relevant line in the table
and click the DELETE button ( ).
Page 121 of 158