D-Link DAP-1360U

DAP-1360U Wireless N300 Access Point & Router
User Manual
Configuring via Web-based Interface
To specify URL addresses to which the selected filtering mode will be applied, in the Addresses
section, click the ADD button ( ). In the opened window, you can specify the following
parameters:
Parameter Description
URL address A URL address, a part of URL address, or a keyword.
Match with template
Select a value from the drop-down list.
Full: The request address should exactly match the value specified
in the field above.
Begin: The request address should begin with the value specified in
the field above.
End: The request address should end with the value specified in the
field above.
Partly: The request address should contain the value specified in
the field above in any part of it.
To remove a URL address from the list, select the checkbox located to the left of the relevant
address in the table and click the DELETE button ( ). Also you can remove an address in the
editing window.
In the Clients section, you can define devices to which the specified restrictions will be applied.
Select a needed value from the Client filtering drop-down list:
• Devices from list: when this value is selected, the access point applies restrictions only to
the devices specified in the Clients section;
• All but devices from list: when this value is selected, the access point does not apply
restrictions to the devices specified in the Clients section, but applies restrictions to other
devices.
To add a client to the list, in the Clients section, click the ADD button ( ). In the opened
window, in the MAC address field, enter the MAC address of the device from the LAN. You can
enter the MAC address of a device connected to the access point’s LAN at the moment. To do this,
select the relevant device from the drop-down list (the field will be filled in automatically). Then
specify a name of the device for easier identification in the Name field and click the SAVE button.
To remove a client from the list, select the checkbox located to the left of the relevant rule of the
table and click the DELETE button ( ). Also you can remove a client in the editing window.
After completing configuration of the URL filter, click the APPLY button.
Page 139 of 158