D-Link DAP-1360U

DAP-1360U Wireless N300 Access Point & Router
User Manual
Configuring via Web-based Interface
Parameter Description
Encryption protocol
Select a method of MPPE encryption.
• No encryption: MPPE encryption is not applied.
• MPPE 40/128 bit: MPPE encryption with a 40-bit or 128-
bit key is applied.
• MPPE 40 bit: MPPE encryption with a 40-bit key is applied.
• MPPE 128 bit: MPPE encryption with a 128-bit key is
applied.
MPPE encryption can be applied only if the MS-CHAP, MS-
CHAPV2, or AUTO value is selected from the Authentication
protocol drop-down list.
Keep Alive
Move the switch to the right if you want the access point to keep
you connected to your ISP even when the connection has been
inactive for a specified period of time. If the switch is moved to the
right, the LCP interval and LCP fails fields are available. Specify
the required values.
Dial on demand
Move the switch to the right if you want the access point to
establish connection to the Internet on demand. In the Maximum
idle time field, specify a period of inactivity (in seconds) after
which the connection should be terminated.
Extra options
Advanced options of the pppd daemon which need to be specified
for this connection. Optional.
Static IP address
Fill in the field if you want to use a static IP address to access the
Internet.
PPP debug
Move the switch to the right if you want to log all data on PPP
connection debugging.
Enable MPPC
(Microsoft Point-to-Point Compression)
For the PPTP type only.
Move the switch to the right if it is necessary to use the data
compression function in order to configure the connection.
Move the switch to the left to disable the function.
Page 73 of 158