D-Link DCS-930L User Manual

44D-Link DCS-930L User Manual
Section 4 - Conguration
System
This section allows you to save and restore your conguration, restore the factory default settings, and reboot the camera.
Save To Local
Hard Drive:
Load From Local
Hard Drive:
Restore To
Factory Default:
Reboot The
Device:
You may save your current camera conguration as a le on your computer by
clicking Save Conguration.
Locate a pre-saved conguration by clicking Choose File and then restore the
pre-dened settings to your camera by clicking Restore Conguration from
File.
You may reset your camera and restore the factory settings by clicking Restore
Factory Defaults.
This will restart your camera.

D-Link DCS-930L Specifications

General

Maximum resolution	640 x 480 pixels
White balance	Auto
Minimum illumination	1 lx
Sensor type	CMOS
Optical sensor size	1/5 \
Digital zoom	4 x
Security algorithms	WEP, WPA, WPA2
Video motion detection	Yes
Cabling technology	10/100Base-T(X)
Supported network protocols	IPV4, ARP, TCP, UDP, ICMP, DHCP, NTP, DNS, DONS, SMTP, FTP, HTTP, PPPoE, UPnP, LLTD
AC input voltage	100-240 V
DC output current	1.2 A
DC output voltage	+5V
AC input frequency	50 - 60 Hz
Power over Ethernet (PoE)	-
Power consumption (typical)	2 W
Ethernet LAN (RJ-45) ports	1
Certification	FCC B, IC, C-Tick, CE
Placement supported	Indoor
Dimensions (WxDxH)	27.2 x 60 x 96 mm
Compatible operating systems	Windows XP / Vista / 7
Flash memory	4 MB
Internal memory	32 MB
Storage temperature (T-T)	-20 - 70 °C
Operating temperature (T-T)	0 - 40 °C
Operating relative humidity (H-H)	20 - 80 %
Form factor	Cube

Weight and Dimensions

Weight	76.9 g