D-Link DCS-930L User Manual

48D-Link DCS-930L User Manual
Section 4 - Conguration
The DCS-930L is a versatile network camera oering both video and audio monitoring. It serves as a powerful surveillance system. The DCS-930L
can be used with any wired or 802.11g/n wireless router. This section explains how to view the camera from either the Internet or from inside your
internal network.
For the basic setup of the DCS-930L, follow the steps outlined in the Quick Install Guide. After you have completed the setup of the DCS-930L as
instructed in the Quick Install Guide, you will have an operating camera with an assigned IP Address. Because you are using a router to share the
Internet with one or more PCs, the IP Address assigned to the network camera will be a local IP Address. This allows viewing within your Local Area
Network (LAN) until the router is congured to allow remote viewing of the camera over the Internet.
Components Needed:
• 1 DCS-930L Day Wi-Fi Network Camera
• 1 Ethernet Cable
• A Wired or Wireless router such as the D-Link DIR-655 Wireless Router
• Ethernet-based PC for system conguration
Setting up the DCS-930L for Use Behind a Router
Installing a DCS-930L network camera on your network is an easy four–step procedure:
1. Assign a local IP address to your network camera.
2. View the network camera using your Internet Explorer web browser.
3. Access the router with your web browser.
4. Open virtual server ports to enable remote image viewing.
Note: These are the steps for manual installation. However, if you decide to use the Setup Wizard, it will perform all steps automatically.
This section is designed to walk you through the setup process for installing your camera behind a router and enabling remote video viewing.
Conguring the DCS-930L without mydlink

D-Link DCS-930L Specifications

General

Maximum resolution	640 x 480 pixels
White balance	Auto
Minimum illumination	1 lx
Sensor type	CMOS
Optical sensor size	1/5 \
Digital zoom	4 x
Security algorithms	WEP, WPA, WPA2
Video motion detection	Yes
Cabling technology	10/100Base-T(X)
Supported network protocols	IPV4, ARP, TCP, UDP, ICMP, DHCP, NTP, DNS, DONS, SMTP, FTP, HTTP, PPPoE, UPnP, LLTD
AC input voltage	100-240 V
DC output current	1.2 A
DC output voltage	+5V
AC input frequency	50 - 60 Hz
Power over Ethernet (PoE)	-
Power consumption (typical)	2 W
Ethernet LAN (RJ-45) ports	1
Certification	FCC B, IC, C-Tick, CE
Placement supported	Indoor
Dimensions (WxDxH)	27.2 x 60 x 96 mm
Compatible operating systems	Windows XP / Vista / 7
Flash memory	4 MB
Internal memory	32 MB
Storage temperature (T-T)	-20 - 70 °C
Operating temperature (T-T)	0 - 40 °C
Operating relative humidity (H-H)	20 - 80 %
Form factor	Cube

Weight and Dimensions

Weight	76.9 g