4
BASIC SWITCH COMMANDS
The basic switch commands in the Command Line Interface (CLI) are listed (along with the appropriate parameters) in the
following table.
Command Parameters
enable password
encryption
disable password
encryption
create account [admin | user] <username 15>
config account <username 15>
show account
delete account <username 15>
show session
show switch
show serial_port
config serial_port { baud_rate [9600|19200|38400|115200] | auto_logout
[never|2_minutes|5_minutes|10_minutes|15_minutes] }(1)
enable clipaging
disable clipaging
enable telnet <tcp_port_number 1-65535>
disable telnet
telnet <ipaddr> {tcp_port <value 0-65535>}
enable web <tcp_port_number 1-65535>
disable web
save {[config {config_id <value 1-2>} | log | all]}
reboot {force_agree}
reset {[config | system ]} { force_agree]}
login
logout
Each command is listed, in detail, in the following sections.
To Next Page
Loading...
Need help?
General