41
LAYER 3 CONTROL PACKET FILTERING
The Layer 3 Control Packet Filtering commands in the Command Line Interface (CLI) are listed (along with the appropriate
parameters) in the following table.
Command Parameters
config cpu_f
ilter l
3_contr
ol_pk
t
<portlist
> [{dvm
rp|pim
|igmp_quer
y|ospf
|rip|vrrp}(1)
| all]
state [e
nable|dis
able]
show cpu_filter l3_control_pkt {<portlist>}
Each command is listed, in detail, in the following sections.
config cpu_filter l3_control_pkt
Purpose This command is used to configure the Layer 3 Control Filter setup of the Switch per port.
Syntax
config cpu_
filter l3_control_p
kt <portlist>
[{dvmrp|pim|igmp_query|
ospf|rip|vrrp}(1
) |
all] state [enable|disable]
Description This command is used to configure the Layer 3 Control Filter setup of the Switch per port.
Parameters
<portlist> - The user can enter a list of ports to be view here.
dvmrp | pim | igmp_query | ospf | rip | vrrp – Specify the L3 Control packet to be filtered.
all – Filter all L3 Control packets. .
state [enable|disable] – The user can set this command’s state to be enabled or disabled.
Restrictions Only Administrator-level users can issue this command.
Example usage:
To configure the Layer 3 Control Filter setup of the Switch per port:
show cpu_filter l3_control_pkt
Purpose This command is used to display the Layer 3 Control Filter setup of the Switch per port.
Syntax
show cpu_filter l3_control_pkt {<portlist>}
Description This command is used to display the Layer 3 Control Filter setup of the Switch per port.
Parameters
<portlist> - The user can enter a list of ports to be view here.
Restrictions None.
Example usage:
To display the Layer 3 Control Filter setup of the Switch per port:
To Next Page
Loading...
Need help?
General