39
PPPOE COMMANDS
The PPPoE commands in the Command Line Interface (CLI) are listed (along with the appropriate parameters) in the following
table.
Command Parameters
config pppoe circuit_id_insertion state [enable | disable]
show pppoe circuit_id_insertion
show pppoe circuit_id_insertion ports {<portlist>}
config pppoe circuit_id_insertion ports <portlist> {state [enable | disable] | circuit_id [mac | ip | udf <string
32>]}(1)
Each command is listed, in detail, in the following sections.
config pppoe circuit_id_insertion state
Purpose Used to enable PPPoE circuit ID insertion operations on the switch.
Syntax
config pppoe circuit_id_insertion state [enable | disable]
Description Used to enable PPPoE circuit ID insertion operations on the switch.
Parameters
state [enable | disable] – The user can enable or disable this option
Restrictions Only Administrator-level users can issue this command.
Example usage
To enable PPPoE circuit ID insertion:
DES-1228/ME:4#config pppoe circuit_id_insertion state enable
Command: config pppoe circuit_id_insertion state enable
Success.
show pppoe circuit_id_insertion
Purpose Used to display PPPoE circuit ID insertion operations on the switch.
Syntax show pppoe circuit_id_insertion
Description Used to display PPPoE circuit ID insertion operations on the switch.
Parameters None
Restrictions None.