45
DHCP SERVER SCREEN LIST
The switch history commands in the Command Line Interface (CLI) are listed (along with the appropriate parameters) in the
following table.
Command Parameters
config filter dhcp_server [add permit server_ip <ipaddr> {client_mac <macaddr>} ports [<portlist>|all]|
delete per
mit s
erver_ip
<ipaddr> {c
lient_m
ac <m
acaddr>} ports
[<por
tlist>|a
ll]
| ports [<portlist>|all] state [enable | disable]]
config filter dhcp_server trap_log [enable| disable]
config filter dhcp_server
illegal_server_log_suppress_duration
[1min | 5min | 30min]
show filter dhcp_server
config filter dhcp_server
Purpose This command is used to configure filtering on the DHCP Server.
Syntax
config filter dhcp_server [add permit server_ip <ipaddr> {client_mac <macaddr>}
ports [<portlist>|all]| delete permit server_ip <ipaddr> {client_mac <macaddr>} ports
[<portli
st>|all] | por
ts [<portlist>|al
l] state [enable | dis
able]]
Description This command is used to configure filtering on the DHCP Server.
Parameters
add permit server_ip <ipaddr> – The user can add a permit server IP address here
delete permit server_ip <ipaddr> - The user can delete a permit server IP address here.
ports [<portlist>|all] – The user can add a defined port list here or select all ports.
client_mac <macaddr> - The user can enter the client MAC address in here.
state [enable | disable] – The user can enable or disable the state of this command here.
Restrictions Only Administrator-level users can issue this command.
Example usage:
To configure filtering on the DHCP Server:
config filter dhcp_server trap_log
Purpose This command is used to configure filtering trap logs for the DHCP Server.
Syntax
config filter dhcp_server trap_log [enable| disable]
Description This command is used to configure filtering trap logs for the DHCP Server.
Parameters
[enable| disable] – The user can enable or disable the trap logs feature in this field.
Restrictions Only Administrator-level users can issue this command.
Example usage:
To Next Page
Loading...
