10
NETWORK MONITORING COMMANDS
The network monitoring commands in the Command Line Interface (CLI) are listed (along with the appropriate parameters) in the
following table.
Command Parameters
show packet ports <portlist>
show error ports <portlist>
show utilization [cpu | ports {<portlist>}]
clear cou
nters
ports <por
tlist>
clear log
show log index <value_list X-Y>
enable syslog
disable syslog
show syslog
create syslog host <index 1-4> ipaddress <ipaddr> {severity [informational | warning | all] | facility [local0 |
local1 | local2 | local3 | local4 | local5 | local6 | local7] | udp_port <udp_port_number>|
state [enable | disable]
config syslog host [all | <index 1-4>] {severity [informational | warning | all] | facility [local0 | local1 | local2 |
local3 | local4 | local5 | local6 | local7] | udp_port <udp_port_number> | ipaddress <ipaddr>
| state [enable | disable]}
delete syslog host [<index 1-4> | all]
show syslog host <index 1-4>
config log_save_timing [time_interval <min 1-65535> | on_demand | log_trigger]
show log_save_timing
Each command is listed, in detail, in the following sections.
show packet ports
Purpose Used to display statistics about the packets sent and received by the Switch.
Syntax
show packet por
ts <portlist>
Description This command is used to display statistics about packets sent and received by ports
specified in the <portlist>.
Parameters
<portlist> − Specifies a port or range of ports to be displayed.
Restrictions None.
Example usage:
To display the packets analysis for port 7 of module 2:
To Next Page
Loading...
Need help?
General