42
LOOPBACK DETECTION COMMANDS
The Loopback Detection commands in the Command Line Interface (CLI) are listed (along with the appropriate parameters) in the
following table.
Command Parameters
config loopdetect { recover_timer [0 | <value 60-1000000>] | interval <value 1-32767>}(1)
config loopdetect ports [<portlist> | all] state [enable | disable]
enable loopdetect
disable loopdetect
show loopdetect
show loopdetect ports [<portlist> | all]
Each command is listed, in detail, in the following sections.
config loopdetect
Purpose Used to configure loopback detection on the switch.
Syntax
config loopdetect { recover_timer [0 | <value 60-1000000>] | interval <value 1-
32767>}(1)
Description Used to configure loopback detection on the switch.
Parameters
recover_timer – The time interval (in seconds) used by the Auto-Recovery mechanism to
decide how long to check if the loop status is gone. The valid range is 60 to 1000000. Zero
is a special value which means to disable the auto-recovery mechanism. The default value is
60.
interval – The time interval (in seconds) at which the remote device transmits all the CTP
packets to detect the loopback event. The default value is 10, with a valid range of 1 to
32767.
Restrictions Only Administrator-level users can issue this command.
Example usage:
To set the recover time to 0, and interval to 20:
To Next Page
Loading...
