28
MAC NOTIFICATION COMMANDS
The MAC notification commands in the Command Line Interface (CLI) are listed, in the following table, along with their
appropriate parameters.
Command Parameters
enable mac_notification
disable mac_notification
config mac_notification {interval <int 1-2147483647>|historysize <int 1-500>}(1)
config mac_notification ports [<portlist> | all] [enable | disable]
show mac_notification
show mac_notification ports <portlist>
Each command is listed, in detail, in the following sections.
enable mac_notification
Purpose Used to enable global MAC address table notification on the Switch.
Syntax
enable mac_notification
Description This command is used to enable MAC address notification without changing configuration.
Parameters None.
Restrictions Only Administrator-level users can issue this command.
Example usage:
To enable MAC notification without changing basic configuration:
disable mac_notification
Purpose Used to disable global MAC address table notification on the Switch.
Syntax
disable mac_notification
Description This command is used to disable MAC address notification without changing configuration.
Parameters None.
Restrictions Only Administrator-level users can issue this command.
Example usage:
To disable MAC notification without changing basic configuration: