D-Link DES-1228 Reference Manual

DES-1228/ME Layer 2 Metro Ethernet Switch CLI Reference Manual
246
37
IGMP SNOOPING MULTICAST VLAN COMMANDS
The IGMP Snooping Multicast VLAN commands in the Command Line Interface (CLI) are listed (along with the appropriate
parameters) in the following table.
Command Parameters
create igmp_snooping
multicast_vlan
<vlan_name 32> <vlanid 2-4094>
config igmp_snooping
multicast_vlan
<vlan_name 32> {[add| delete] [member_port <portlist> | tag_member_port <portlist>
|source_port <portlist>]|state [enable | disable]|replace_source_ip [<ipaddr>|none]}(1)
config igmp_snooping
multicast_vlan_group
<vlan_name 32> [ add <mcast_address_list> | delete [<mcast_address_list>
| all]]
show igmp_snooping
multicast_vlan_group
{< vlan_name 32> }
delete igmp_snooping
multicat_vlan
<vlan_name 32>
enable igmp_snooping
multicast_vlan
disable igmp_snooping
multicast_vlan
show igmp_snooping
multicast_vlan
{<vlan_name 32>}
Each command is listed, in detail, in the following sections.
create igmp_snooping multicast_vlan
Purpose Used to create a multicast VLAN
Syntax
create igmp_snooping multicast_vlan <vlan_name 32> <vlanid 2-4094>
Description The create igmp_snooping multicast_vlan command will create a multicast_vlan. Multiple
multicast VLAN can be configured.
The ISM VLAN being created can not exist in the 1Q VLAN database. Multiple ISM VLAN
can be created. The ISM VLAN snooping function co-exist with the 1Q VLAN snooping
function.
Parameters
<vlan_name> − The name of the VLAN to be created. Each multicast VLAN is given a
name that can be up to 32 characters.
<vlanid> – The VLAN ID of the multicast VLAN to be create. The range is 2-4094
Restrictions Only Administrator-level users can issue this command.

D-Link DES-1228 Specifications

General

Brand	D-Link
Model	DES-1228
Category	Switch
Language	English