D-Link DES-1228 - Page 159

DES-1228/ME Layer 2 Metro Ethernet Switch CLI Reference Manual
154
Port number : 1
Capability : None
AdminCrlDir : Both
OpenCrlDir : Both
Port Control : Auto
QuietPeriod : 60 sec
TxPeriod : 30 sec
SuppTimeout : 30 sec
ServerTimeout : 30 sec
MaxReq : 2 times
ReAuthPeriod : 3600 sec
ReAuthenticate : Disabled
CTRL+C ESC q Quit SPACE n Next Page p Previous Page r Refresh
show 802.1x auth_state
Purpose Used to display the current authentication state of the 802.1X server on the Switch.
Syntax
show 802.1x auth_state {ports <auth_portlist>}
Description
The show 802.1x auth_state command is used to display the current authentication state
of the 802.1X Port-based or Host-based Network Access Control application on the
Switch.
Parameters
<auth_portlist> − Specifies a port or range of ports to be viewed.
The following details what is displayed:
Port number − Shows the physical port number on the Switch.
Auth PAE State: Initalize / Disconnected / Connecting / Authenticating / Authenticated /
Held / ForceAuth / ForceUnauth − Shows the current state of the Authenticator PAE.
Backend State: Request / Response / Fail / Idle / Initalize / Success / Timeout − Shows the
current state of the Backend Authenticator.
Port Status: Authorized / Unauthorized − Shows the result of the authentication process.
Authorized means that the user was authenticated, and can access the network.
Unauthorized means that the user was not authenticated, and cannot access the network.
Restrictions None.
Example usage:
To display the 802.1X auth state for Port-based 802.1X:
DES-1228/ME:4#show 802.1x auth_state
Command: show 802.1x auth_state
Port Auth PAE State Backend State Port Status
------ ----------------- ----------------- -----------------
1 ForceAuth Success Authorized
2 ForceAuth Success Authorized
3 ForceAuth Success Authorized