D-Link DES-1228 - Page 216

DES-1228/ME Layer 2 Metro Ethernet Switch CLI Reference Manual
211
show authen_enable
all – Entering this parameter will display all the authentication login methods currently
configured on the Switch.
The window will display the following parameters:
 Method List Name – The name of a previously configured method list name.
 Priority – Defines which order the method list protocols will be queried for
authentication when a user attempts to log on to the Switch. Priority ranges from
1(highest) to 4 (lowest).
 Method Name – Defines which security protocols are implemented, per method
list name.
 Comment – Defines the type of Method. User-defined Group refers to server
groups defined by the user. Built-in Group refers to the TACACS, XTACACS,
TACACS+ and RADIUS security protocols which are permanently set in the
Switch. Keyword refers to authentication using a technique INSTEAD of
TACACS/XTACACS/TACACS+/RADIUS which are local (authentication through
the local_enable password on the Switch) and none (no authentication necessary
to access any function on the Switch).
Restrictions None.
Example usage:
To display all method lists for promoting user level privileges to administrator level privileges.
DES-1228/ME:4#show authen_enable all
Command: show authen_enable all
Method List Name Priority Method Name Comment
---------------- -------- ------------- ------------------
Permit 1 tacacs+ Built-in Group
2 tacacs Built-in Group
3 Darren User-defined Group
4 local Keyword
default 1 tacacs+ Built-in Group
2 local Keyword
Total Entries : 2
DES-1228/ME:4#
config authen application
Purpose Used to configure various applications on the Switch for authentication using a previously
configured method list.
Syntax
config authen application [console | telnet | ssh | http | all] [login | enable] [default |
method_list_name <string 15>]
Description This command is used to configure Switch configuration applications (console, telnet, ssh,
web) for login at the user level and at the administration level (authen_enable) utilizing a
previously configured method list.
Parameters
application – Choose the application to configure. The user may choose one of the
following five options to configure.
 console – Choose this parameter to configure the command line interface login
method.
 telnet – Choose this parameter to configure the telnet login method.