D-Link DES-1228 - Page 228

DES-1228/ME Layer 2 Metro Ethernet Switch CLI Reference Manual
223
enable ssh
Purpose Used to enable SSH.
Syntax
enable ssh
Description This command allows users to enable SSH on the Switch.
Parameters None.
Restrictions Only Administrator-level users can issue this command.
Usage example:
To enable SSH:
DES-1228/ME:4#enable ssh
Command: enable ssh
Success.
DES-1228/ME:4#
disable ssh
Purpose Used to disable SSH.
Syntax
disable ssh
Description This command allows users to disable SSH on the Switch.
Parameters None.
Restrictions Only Administrator-level users can issue this command.
Usage example:
To disable SSH:
DES-1228/ME:4# disable ssh
Command: disable ssh
Success.
DES-1228/ME:4#
config ssh authmode
Purpose Used to configure the SSH authentication mode setting.
Syntax
config ssh authmode [password | publickey | hostbased] [enable | disable]
Description This command will allow users to configure the SSH authentication mode for users
attempting to access the Switch.