D-Link DES-1228 - Page 235

DES-1228/ME Layer 2 Metro Ethernet Switch CLI Reference Manual
230
Command Parameters
enable smtp
disable smtp
config smtp {server <ipaddr> | server_port <tcp_port_number 1-65535> |self_mail_addr <mail_addr
64> |[add mail_receiver <mail_addr 64> | delete mail_receiver <index 1-8>]}(1)
show smtp
smtp send_testmsg
Each command is listed, in detail, in the following sections.
enable smtp
Purpose Used to enable the Switch as a SMTP client.
Syntax
enable smtp
Description
This command, in conjunction with the disable smtp command will enable and disable
the Switch as a SMTP client without changing configurations.
Parameters None.
Restrictions Only Administrator-level users can issue this command.
Example usage:
To enable SMTP on the Switch.
DES-1228/ME:4#enable smtp
Command: enable smtp
Success.
DES-1228/ME:4#
disable smtp
Purpose Used to disable the Switch as a SMTP client.
Syntax
disable smtp
Description
This command, in conjunction with the enable smtp command will enable and disable the
Switch as a SMTP client without changing configurations.
Parameters None.
Restrictions Only Administrator-level users can issue this command.
Example usage:
To disable SMTP on the Switch.
DES-1228/ME:4#disable smtp
Command: disable smtp
Success.
DES-1228/ME:4#
config smtp
Purpose Used to configure necessary information in setting up the Switch as an SMTP client.