reset
Purpose Used to reset the Switch to the factory default settings.
Syntax
reset {[config | system]} {force_agree}
Description This command is used to restore the Switch’s configuration to the default settings
assigned from the factory.
Parameters
config - If the keyword ‘config’ is specified, all of the factory default settings are
restored on the Switch including the IP address, user accounts, and the switch history log.
The Switch will not save or reboot.
system − If the keyword ‘system’ is specified all of the factory default settings are restored
on the Switch. The Switch will save and reboot after the settings are changed to default.
Rebooting will clear all entries in the Forwarding Data Base.
force_agree – When force_agree is specified, the reset command will be executed
immediately without further confirmation.
If no parameter is specified, the Switch’s current IP address, user accounts, and the switch
history log are not changed. All other parameters are restored to the factory default
settings. The Switch will not save or reboot.
Restrictions Only Administrator-level users can issue this command.
Example usage:
To restore all of the Switch’s parameters to their default values:
login
Purpose Used to log in a user to the Switch’s console.
Syntax
login
Description This command is used to initiate the login procedure. The user will be prompted for a
Username and Password.
Parameters None.
Restrictions None.
Example usage:
To initiate the login procedure:
To Next Page
Loading...
