D-Link DES-1228 - Page 267

DES-1228/ME Layer 2 Metro Ethernet Switch CLI Reference Manual
262
Example usage
To display the LLDP per port TLV option configuration:
DES-1228/ME:4# show lldp ports 1
Command: show lldp ports 1
Port ID : 1
----------------------------------------------------------------------
Admin Status : TX_and_RX
Notification Status : Disable
Advertised TLVs Option :
Port Description Disable
System Name Disable
System Description Disable
System Capabilities Disable
Enabled Management Address
(NONE.)
Port VLAN ID Disable
Enabled VLAN Name
(NONE.)
Enabled protocol_identity
(NONE.)
MAC/PHY Configuration/Status Disable
Link Aggregation Disable
Maximum Frame Size Disable
DES-1228/ME:4#
show lldp local_ports
Purpose Used to display the per-port information currently available for populating outbound LLDP
advertisements.
Syntax
show lldp local_ports {<portlist>} {mode [brief | normal | detailed]}
Description This command displays the per-
port information currently available for populating
outbound LLDP advertisements.
Parameters
<portlist> − Specified a range of ports to be configured. When a port list is not specified,
information for all ports will be displayed.
brief − Display the information in brief mode.
normal − Display the information in normal mode. This is the default display mode.
detailed − Display the information in detailed mode.
Restrictions None.