D-Link DES-1228 - Page 269

DES-1228/ME Layer 2 Metro Ethernet Switch CLI Reference Manual
264
DES-1228/ME:4#show lldp local_ports 1 mode normal
Command: show lldp local_ports 1 mode normal
Port ID : 1
-------------------------------------------------------------------------
Port Id Subtype : Local
Port Id : 1/1
Port Description : D-Link DES-1228/ME R1.00 Port 1
Port PVID : 1
Management Address Count : 1
PPVID Entries Count : 0
VLAN Name Entries Count : 1
Protocol Identity Entries Count : 0
MAC/PHY Configuration/Status : (See detail)
Power Via MDI : (See detail)
Link Aggregation : (See detail)
Maximum Frame Size : 1536
DES-1228/ME:4#
To display outbound LLDP advertisements for specific ports in brief mode:
DES-1228/ME:4#show lldp local_ports 1 mode brief
Command: show lldp local_ports 1 mode brief
Port ID : 1
-------------------------------------------------------------------------
Port Id Subtype : Local
Port Id : 1/1
Port Description : D-Link DES-1228/ME R1.00 Port 1
DES-1228/ME:4#
show lldp remote_ports
Purpose Used to display the information learned from the neighbor.
Syntax
show lldp remote_ports {<portlist>} {mode [brief | normal | detailed]}
Description This command displays information learnt from the neighbor parameters.
Due to the memory limitations, the switch can only receive 32 VLAN Name entries and 10
Management Address entries.
Parameters
<portlist> − Specified a range of ports to be configured. When a port list is not specified,
information for all ports will be displayed.
brief − Display the information in brief mode.
normal − Display the information in normal mode. This is the default display mode.
detailed − Display the information in detailed mode.
Restrictions None.