DES-1228/ME Layer 2 Metro Ethernet Switch CLI Reference Manual
274
DES-1228/ME:4#create address_binding ip_mac ipaddress 10.1.1.3 mac_address 00-00-00-00-
00-04
Command: create address_binding ip_mac ipaddress 10.1.1.3 mac_address 00-00-00-00-00-04
Success.
config address_binding ip_mac ipaddress
Purpose Used to configure an IP-MAC Binding entry.
Syntax
config address_binding ip_mac ipaddress <ipaddr> mac_address <macaddr> {ports
[<portlist> | all]}
Description This command will configure an IP-MAC Binding entry.
Parameters
<ipaddr> – The IP address of the device where the IP-MAC binding is made.
<macaddr> – The MAC address of the device where the IP-MAC binding is made.
<portlist> – Specifies a port or range of ports to be configured for address binding.
all – Specifies that all ports on the switch will be configured for address binding.
Restrictions Only Administrator-level users can issue this command.
Example usage:
To configure address binding on the Switch:
DES-1228/ME:4#config address_binding ip_mac ipaddress 10.1.1.3 mac_address 00-00-00-00-
00-05
Command: config address_binding ip_mac ipaddress 10.1.1.3 mac_address 00-00-00-00-00-05
Success.
config address_binding ip_mac ports
Purpose Used to configure an IP-MAC state to enable or disable for specified ports.
Syntax
config addr
ess_binding ip_mac por
ts [<portlist>
| all] state [enable | di
sable]
allow_zeroip [enable | disable]
Description This command will configure IP-MAC state to enable or disable for specified ports.
Parameters
<portlist> − Specifies a port or range of ports.
all – specifies all ports on the switch.
state [enable | disable] – Enables or disables the specified range of ports.
Restrictions Only Administrator-level users can issue this command.
Example usage:
To configure address binding on the Switch:
To Next Page
Loading...
