D-Link DES-1228 - Page 44

DES-1228/ME Layer 2 Metro Ethernet Switch CLI Reference Manual
39
Example usage:
To display the currently entered SNMP community strings:
DES-1228/ME:4#show snmp community
Command: show snmp community
SNMP Community Table
Community Name View Name Access Right
------------------ ------------------- ------------
private CommunityView read_write
public CommunityView read_only
dlink ReadView read_write
Total Entries: 3
DES-1228/ME:4#
config snmp engineID
Purpose Used to configure a name for the SNMP engine on the Switch.
Syntax
config snmp engineID <snmp_engineID>
Description
The config snmp engineID command configures a name for the SNMP engine on the
Switch.
Parameters
<snmp_engineID> − An alphanumeric string that will be used to identify the SNMP engine
on the Switch.
Restrictions Only Administrator-level users can issue this command.
Example usage:
To give the SNMP agent on the Switch the name “0035636666”
DES-1228/ME:4#config snmp engineID 0035636666
Command: config snmp engineID 0035636666
Success.
DES-1228/ME:4#
show snmp engineID
Purpose Used to display the identification of the SNMP engine on the Switch.
Syntax
show snmp engineID
Description
The show snmp engineID command displays the identification of the SNMP engine on
the Switch.
Parameters None.
Restrictions None.