DES-3028 DES-3028P DES-3028G DES-3052 DES-3052P Layer 2 Fast Ethernet Managed Switch
VLAN in the Modify dialog
box. VLANs can be identified by their VID.
Action
Choose an action to Create, Configure or Delete an 802.1Q Static VLAN.
Advertisement
Use the pull down menu to Enable or Disable the Advertisement broadcast on the VLAN.
Port Settings
Allows an individual port to be specified as member of a VLAN.
Tag
Specifies the port as either 802.1Q tagging or 802.1Q untagged. Checking the box will desig-
nate the port as Tagged.
None
Allows an individual port to be specified as a non-VLAN member.
Egress
Select this to specify the port as a static member of the VLAN. Egress member ports are ports
that will be transmitting traffic for the VLAN. These ports can be either tagged or untagged.
Forbidden
Select this to specify the port as not being a member of the VLAN and that the port is
forbidden from becoming a member of the VLAN dynamically.
Click Apply to implement changes made. Click the Show All Static VLAN Entries link to return to the 802.1Q Static VLANs
window.
GVRP Settings
The GVRP Settings window, shown below, allows you to determine whether the Switch will share its VLAN configuration
information with other GARP VLAN Registration Protocol (GVRP) enabled switches. In addition, Ingress Checking can be used
to limit traffic by filtering incoming packets whose PVID does not match the PVID of the port. Results can be seen in the table
under the configuration settings, as seen below. To view this window click L2 Features > VLAN > GVRP Settings.
92
To Next Page
Loading...
