DES-3028 DES-3028P DES-3028G DES-3052 DES-3052P Layer 2 Fast Ethernet Managed Switch
Parameter Description
From/To
Select a port or group of ports using the pull-down menus.
Notification State
update. In addition, the changed type includes any data update
Used to configure each port for sending notification to configured SNMP trap receiver(s).
Enable or disable each port for sending change notification to configured SNMP trap
receiver(s) if an LLDP data change is detected in an advertisement received on the port from
an LLDP neighbor. The definition of change includes new available information, information
timeout, and information
/insert/remove.
Admin Status
Use the drop-down menu to choose: TX_Only, RX_Only, TX_and_RX, or Disabled.
Port Description
. Use the drop-down menu to toggle Port Description between Enabled and Disabled
System Name
Use the drop-down menu to toggle System Name between Enabled and Disabled.
System Description
Use the drop-down menu to toggle System Description between Enabled and Disabled.
System Capabilities
Use the drop-down menu to toggle System Capabilities between Enabled and Disabled.
Click Apply to implement changes made.
802.1 Extension LLDP Port Settings
The following window is used to set up 802.1 extension LLDP on individual port(s) on the Switch. To view this window click L2
Features > LLDP > 802.1 Extension LLDP Port Settings.
134
To Next Page
Loading...
