D-Link DES-3028 - Basic LLDP Port Settings

To Next Page

To Previous Page

DES-3028 DES-3028P DES-3028G DES-3052 DES-3052P Layer 2 Fast Ethernet Managed Switch

Basic LLDP Port Settings

The following window is used to set up LLDP on individual port(s) on the Switch. To view this window click L2 Features >

LLDP > Basic LLDP Port Settings.

Figure 7- 48. Basic LLDP Port Settings window

The following parameters can be set or displayed:

133

Main Page

Default Chapter1
- User Manual1
- Table of Contents3
Preface9
Intended Readers10
Typographical Conventions10
Notes, Notices, and Cautions10
Safety Instructions11
- Safety Cautions11
- General Precautions for Rack-Mountable Products12
- Protecting against Electrostatic Discharge13
Introduction14
Des-3028/28P/28G/52/52P14
- Features14
- Ports16
- LED Indicators17
- Front-Panel Description19
- Rear Panel Description20
- Side Panel Description20
- Gigabit Combo Ports21
- Installing the SFP Ports22
Installation23
- Package Contents23
- Before You Connect to the Network23
- Installing the Switch Without the Rack24
- Installing the Switch in a Rack24
- Mounting the Switch in a Standard 19" Rack25
Connecting the Switch26
- Switch to End Node26
- Switch to Hub or Switch27
Introduction to Switch Management28
Management Options28
- Web-Based Management Interface28
- SNMP-Based Management28
- Connecting the Console Port (RS-232 DCE)28
- First Time Connecting to the Switch30
- Password Protection30
- SNMP Settings31
- IP Address Assignment32
Web-Based Switch Configuration35
Introduction35
- Login to Web Manager35
- Web-Based User Interface36
- Web Pages38
Administration39
Device Information40
IP Address42
- Setting the Swith's IP Address Using the Console Interface44
Port Configuration45
- Port Settings45
- Port Description47
- Port Error Disabled47
DHCP/BOOTP Relay49
- DHCP/BOOTP Relay Global Settings49
- DHCP/BOOTP Relay Interface Settings52
- DHCP Local Relay Settings52
User Accounts54
Cable Diagnostics56
Port Mirroring58
System Log Settings59
Log Settings61
SNTP Settings62
- Time Settings62
- Time Zone and DST63
MAC Notification Settings65
TFTP Services66
Multiple Image Services67
- Firmware Information67
- Config Firmware Image67
Ping Test68
Safeguard Engine68
SNMP Manager71
- SNMP Settings71
- SNMP Traps Settings72
- SNMP User Table72
- SNMP View Table74
- SNMP Group Table75
- SNMP Community Table Configuration76
- SNMP Host Table77
- SNMP Engine ID78
Poe System79
- Poe System Configuration79
- Poe Port Configuration80
Single IP Settings82
- SIM Settings83
- Parameters Description84
- Topology85
- Icon Description86
- Tool Tips87
- Right-Click88
- Menu Bar90
- Firmware Upgrade91
- Configuration Backup/Restore91
- Upload Log92
Forwarding & Filtering92
- Unicast Forwarding92
- Multicast Forwarding93
- Multicast Filtering Mode95
SMTP Service96
- SMTP Server Settings97
- SMTP Service97
L2 Features99
Vlans99
- Q Vlan Tags100
- Ingress Filtering101
- Tagging and Untagging101
- Default Vlans102
- Vlan Segmentation102
- Asymmetric Vlans103
- Static VLAN Entry104
- GVRP Settings106
- VLAN Trunk Settings108
- Qinq110
Trunking112
- Link Aggregation113
- LACP Port Settings113
IGMP Snooping115
- Router Ports Settings117
- IGMP Authentication119
- Dynamic IP Multicast Learning121
- ISM VLAN Settings122
- IP Multicast Filter Profile Settings124
- Limited Multicast Range Settings125
- Max Multicast Group Settings127
MLD Snooping128
- MLD Snooping Settings128
- MLD Snooping Router Port Settings130
Spanning Tree131
- Port Transition States132
- W Rapid Spanning Tree132
- Edge Port133
- P2P Port133
- STP Bridge Global Settings134
- STP Port Settings137
- MST Configuration Identification139
- STP Instance Settings141
- MSTP Port Information142
Loopback Detection Settings144
Lldp145
- LLDP Global Settings145
- Basic LLDP Port Settings147
- 802.1 Extension LLDP Port Settings148
- Extension LLDP Port Settings150
- LLDP Management Address Settings152
- LLDP Statistics153
- LLDP Management Address Table154
- LLDP Local Port Table154
- LLDP Remote Port Table156
Cos157
- Understanding Cos158
Port Bandwidth160
802.1P Default Priority161
802.1P User Priority163
Cos Scheduling Mechanism163
Cos Output Scheduling164
Priority Settings165
TOS Priority Settings167
DSCP Priority Settings168
Port Mapping Priority Settings169
MAC Priority170
Acl171
Time Range171
Access Profile Table171
CPU Interface Filtering183
- CPU Interface Filtering State183
- CPU Interface Filtering Profile Table183
Security195
Traffic Control195
Port Security199
Port Lock Entries200
IP-MAC-Port Binding201
- IMP Global Settings201
- IMP Port Settings201
- IMP Entry Settings203
- DHCP Snooping Entries204
- MAC Block List204
Ssl205
- Download Certificate205
- Ciphersuite205
Ssh208
- SSH Server Configuration208
- SSH Authentication Mode and Algorithm Settings209
- SSH User Authentication211
802.1X219
- 802.1X Authenticator Settings219
- Local Users222
- 802.1X Capability Settings223
- Configure 802.1X Guest VLAN223
- Initializing Ports for Port Based 802.1X224
- Initializing Ports for Host Based 802.1X225
- Reauthenticate Port(S) for Port Based 802.1X226
- Reauthenticate Port(S) for Host-Based 802.1X227
- RADIUS Server227
Trusted Host228
Access Authentication Control229
- Authentication Policy and Parameter Settings230
- Application Authentication Settings230
- Authentication Server Group231
- Authentication Server Host232
- Login Method Lists235
- Enable Method Lists236
- Configure Local Enable Password239
- Enable Admin239
Traffic Segmentation240
Dos Attack Prevention241
Monitoring246
CPU Utilization246
Port Utilization247
Packets248
- Received (RX)249
- UMB Cast (RX)251
- Transmitted (TX)253
Packet Errors255
- Received (RX)255
- Transmitted (TX)257
Packet Size259
MAC Address261
Switch Log263
IGMP Snooping Group264
Browse Router Port265
VLAN Status265
MLD Snooping Group265
Browse MLD Snooping Router Port266
Static ARP Settings267
Arp-Fdb267
Gratuitous ARP Settings269
Session Table270
Port Access Control270
- RADIUS Authentication270
- RADIUS Accounting272
Reset273
Reboot System274
Save Changes274
Logout275
Technical Specifications276
System Log Entries282
- Standard Trap List292
- Proprietary Trap List293
- Proprietary Trap List (Project Dependent)293
Cable Lengths295
Password Recovery Procedure296
Glossary298
ARP Packet Content ACL300
- Fcc Warning308
- Ce Mark Warning308
- VCCI Warning308
Warranties/Registration310
- Copyright Statement311
- Product Registration314
- Limited Warranty315
Tech Support319
- Technical Support320
- Assistance Technique321
- Pomoc Techniczna322

D-Link DES-3028 - Basic LLDP Port Settings

Table of Contents

Other manuals for D-Link DES-3028

Related product manuals