D-Link DES-3028 - SNMP Traps Settings; SNMP User Table

DES-3028 DES-3028P DES-3028G DES-3052 DES-3052P Layer 2 Fast Ethernet Managed Switch
SNM
P settings are configured using the menus located on the SNMP V3 folder of the web manager. Workstations on the network
that are allowed SNMP privileged access to the Switch can be restricted with the Trusted Host IP Management window in the
Security folder of the web manager. .
SNMP Traps Settings
The following window is used to enable and disable trap settings for the SNMP function on the Switch. To view this window for
configuration, click Administration > SNMP Manager > SNMP Trap Settings:
Figure 6- 30. SNMP Trap Settings window
To enable or disable the Traps State and/or the Authenticate Traps State, use the corresponding pull-down menu to change and
click Apply.
SNMP User Table
This window displays all of the SNMP User's currently configured on the Switch. . To view this window, click Administration >
SNMP Manager > SNMP User Table:
Figure 6- 31. SNMP User Table window
To delete an existing SNMP User Table entry, click the
below the Delete heading corresponding to the entry you wish to
delete.
To display the detailed entry for a given user, click on the hyperlinked username under the Display heading. This will open the
SNMP User Table Display window, as shown below.
Figure 6- 32. SNMP User Table Display window
The following parameters are displayed:
Parameter Description
User Name
An alphanumeric string of up to 32 characters. This is used to identify the SNMP users.
58