DES-3028 DES-3028P DES-3028G DES-3052 DES-3052P Layer 2 Fast Ethernet Managed Switch
The
following parameters may be configured or viewed.
Parameter Description
40
DHCP/BOOTP Local
Rela
y Operation State
Used to Enable or Disable the DHCP/BOOTP Local Relay Operation State.
VLAN Name
This is the VLAN Name that identifies the VLAN the user wishes to apply the
DHCP/BOOTP Local Relay Operation.
VID List
This is the VLAN ID that identifies the VLAN list the user wishes to apply the
DHCP/BOOTP Local Relay Operation.
State
Enable or Disable the DHCP/BOOTP Local Relay Settings state.
Click Apply to implement changes made.
User Accounts
Use the User Account Management window to control user privileges. To view existing User Accounts, open the
Administration folder and click on the User Accounts link. This will open the User Account Management window, as shown
below.
Figure 6- 11. User Accounts window
To add a new user, click on the Add button.
Figure 6- 12. User Account Modify Table window
Add a new user by typing in a User Name, and New Password and retype the same password in the Confirm New Password.
Choose the level of privilege (Admin or User) from the Access Right drop-down menu. To return to the User Account Table click
the hyperlinked Show All User Account Entries
.
NOTE: In case of lost passwords or password corruption, please refer to the D-Link website
and the White Paper entitled “Password Recovery Procedure”, which will guide you through the
steps necessary to resolve this issue.
To modify or delete an existing user, click on the Modify button for that user.
To Next Page
Loading...
