DES-3028 DES-3028P DES-3028G DES-3052 DES-3052P Layer 2 Fast Ethernet Managed Switch
Figure 9- 8. Access Rule Display window (IP)
To configure the Access Rule for Ethernet, open the Access Profile Table and click Modify for an Ethernet entry. If no entry
exists only the Add button will be displayed however when an entry already exists a corresponding Modify button will also be
displayed. This will open the following window:
Figure 9- 9. Access Rule Table window (Ethernet)
The user may display a particular Access ID entry by clicking the corresponding View button.
To remove a previously created rule, select it and click the
button. To add a new Access Rule, click the Add button:
164
To Next Page
Loading...
