xStack DES-3528 Series Layer 2 Stackable Fast Ethernet Managed Switch User Manual
The user may set the following parameters:
Parameter Description
From Port/To Port
A consecutive group of ports may be configured starting with the selected port.
State
Choose Enabled to enable the DHCP server or Disabled to disable. The default is Disabled.
After setting the previous parameters, click Apply to allow your changes to be implemented. The DHCP Port
Information Table shows which ports are enabled or disabled for DHCP Sever Screening.
DHCP Offer Filtering
The following window will allow users to configure the DHCP Server Settings on the switch. To view this window, click
Security > DHCP Server Screening > DHCP Offer Filtering:
Figure 9- 12. DHCP Offer Filtering window
The user may set the following parameters:
Parameter Description
Server IP Address
The IP address of the DHCP server.
Client’s MAC Address
The MAC address of the Client.
Ports
Choose the range of ports that you want to use as the DHCP server, or check the All Ports
box if you wish to use all the ports on the switch.
After setting the previous parameters, click Apply to allow your changes to be implemented.
135
To Next Page
Loading...
