D-Link DES-3528 - Timezone Settings

xStack DES-3528 Series Layer 2 Stackable Fast Ethernet Managed Switch User Manual
45
TimeZone Settings
The following window is used to configure time zones and Daylight Savings time settings for SNTP. To configure the
time Zone Settings for the Switch, click Configuration > SNTP Settings > TimeZone Settings:
Figure 6- 26. Time Zone and DST Settings window
The following parameters can be set:
Parameter Description
Time Zone and DST
Daylight Saving
Time State
Use this pull-down menu to enable or disable the DST Settings.
Daylight Saving
Time Offset in
Minutes
Use this pull-down menu to specify the amount of time that will constitute your local DST offset
- 30, 60, 90, or 120 minutes.
Time Zone Offset
from GMT in +/-
HH:MM
Use these pull-down menus to specify your local time zone's offset from Greenwich Mean
Time (GMT.)
DST Repeating Settings
Using repeating mode will enable DST seasonal time adjustment. Repeating mode requires that the DST beginning
and ending date be specified using a formula. For example, specify to begin DST on Saturday during the second
week of April and end DST on Sunday during the last week of October.
From :Which Week
of the Month
Enter the week of the month that DST will start.
From: Day of the
Week
Enter the day of the week that DST will start on.