xStack® DGS-3620 Series Managed Switch Web UI Reference Guide
111
MLD Proxy
MLD Proxy Settings
This window is used to configure the MLD proxy state and MLD proxy upstream interface.
To view the following window, click L2 Features > L2 Multicast Control > MLD Proxy > MLD Proxy Settings, as
show below:
Figure 4-65 MLD Proxy Settings window
The fields that can be configured are described below:
Parameter Description
MLD Proxy State
Use the radio buttons to enable or disable the MLD Proxy Global State.
VLAN Name
Click the radio button and enter the VLAN name for the interface.
VID
Click the radio button and enter the VLAN ID for the interface.
Source IP Address
Enter the source IPv6 address of the upstream protocol packet. If it is not specified,
zero IP address will be used as the protocol source IP address.
Unsolicited Report
Interval (0-25)
The Unsolicited report interval. It is the time between repetitions of the host's initial
report of membership in a group. Default is 10 seconds. If set to 0, it means to send
only one report packet.
Unit
Select the unit you wish to configure.
Static Router Port
Select the port that will be included in this configuration.
Click the Apply button to accept the changes made for each individual section.
Click the Select All button to select all the ports for configuration.
Click the Clear All button to unselect all the ports for configuration.
MLD Proxy Downstream Settings
This window is used to configure the MLD proxy downstream interface in this page. The MLD proxy downstream
interface must be an MLD snooping enabled VLAN.
To view the following window, click L2 Features > L2 Multicast Control > MLD Proxy > MLD Proxy
Downstream Settings, as show below:
To Next Page
Loading...
