D-Link DGS-3620-28PC-SI - BGP as Path Access Settings

xStack® DGS-3620 Series Managed Switch Web UI Reference Guide
247
Confederation Peer AS
List (1-65535)
Enter one or multiple AS number partitions, each separated by a comma. These are
the Autonomous System numbers for BGP peers that will belong to the
confederation.
Click the Apply button to accept the changes made.
BGP AS Path Access Settings
This window is used to configure an Autonomous System path access list.
To view the following window, click L3 Features > BGP > BGP AS Path Access Settings, as shown below:
Figure 5-133 BGP AS Path Access Settings window
The fields that can be configured are described below:
Parameter Description
List Name
Enter an Autonomous System path access list name.
Click the Add button to add a new entry based on the information entered.
Click the Find button to locate a specific entry based on the information entered.
Click the Delete All button to remove all the entries listed.
Click the View All button to display all the existing entries.
Click the
View Detail
Click the Delete button to remove the specific entry.
link to view more information regarding the specific entry.
Click the
View Detail link to see the following window.
Figure 5-134 BGP AS Path Access Settings - View Detail window
The fields that can be configured are described below:
Parameter Description
Mode Use the drop-down menu to Permit or Deny advertisement based on matching
conditions.
Regular Expression
Enter the regular expression that defines the AS path filter.
Click the Apply button to accept the changes made.
Click the <<Back button to return to the previous window.
Click the Delete button to remove the specific entry.