D-Link DGS-3620-28PC-SI - DHCP Relay Settings

xStack® DGS-3620 Series Managed Switch Web UI Reference Guide
392
Figure 9-4 DHCP Relay Interface Settings window
The fields that can be configured are described below:
Parameter Description
Interface Name
The IP interface on the Switch that will be connected directly to the client.
Server IP Address
Enter the IP address of the DHCP server. Up to four server IPs can be configured per
IP Interface.
Click the Apply button to accept the changes made.
DHCP Relay Option 60 Server Settings
On this page the user can configure the DHCP relay option 60 server parameters.
To view this window, click Network Application > DHCP > DHCP Relay > DHCP Relay Option 60 Server
Settings as shown below:
Figure 9-5 DHCP Relay Option 60 Server Settings window
The fields that can be configured are described below:
Parameter Description
Server IP Address
Enter the DHCP Relay Option 60 Server Relay IP Address.
Mode
Use the drop-down menu to select the DHCP Relay Option 60 Server mode.
Click the Add button to add a new entry based on the information entered.
Click the Apply button to accept the changes made.
Click the Delete button to remove the specific entry.
Click the Delete All button to remove all the entries listed.
NOTE: When there is no matching server found for the packet based on option 60, the relay servers
will be determined by the default relay server setting.
DHCP Relay Option 60 Settings
This option decides whether the DHCP Relay will process the DHCP option 60 or not
To view this window, click Network Application > DHCP > DHCP Relay > DHCP Relay Option 60 Settings as
shown below: