xStack® DGS-3620 Series Managed Switch Web UI Reference Guide
154
Figure 5-1 IPv4 Static/Default Route Settings window
The fields that can be configured are described below:
Parameter Description
IP Address
This field allows the entry of an IPv4 address to be assigned to the Static route. Tick the
Default check box to be assigned to the default route.
Netmask
This field allows the entry of a subnet mask to be applied to the corresponding subnet
check box and enter the IP tunnel name used.
Gateway
This field allows the entry of a Gateway IP Address to be applied to the corresponding
gateway of the IP address.
Metric (1-65535)
Represents the metric value of the IP interface entered into the table. This field may read
a number between 1 and 65535.
Backup State
Each IP address can only have one primary route, while other routes should be assigned
to the backup state. When the primary route failed, switch will try the backup routes
according to the order learnt by the routing table until route success. The field represents
the Backup state that the Static and Default Route is configured for.
Use the drop-down menu to enable or disable the null interface as the next hop.
Click the Apply button to accept the changes made.
IPv4 Route Table
The IP routing table stores all the external routes information of the switch. This window displays all the external
route information on the Switch.
To view the following window, click L3 Features > IPv4 Route Table, as show below:
Figure 5-2 IPv4 Route Table window
The fields that can be configured are described below:
To Next Page
Loading...
