D-Link DGS-3620-28PC-SI - Adding an Ipv4 Egress Acl Profile

xStack® DGS-3620 Series Managed Switch Web UI Reference Guide
309
error message and the access rule will not be configured.
Port Group ID
Specify the port group ID to apply to the access rule.
Port Group Name
Specify the port group name to apply to the access rule.
VLAN Name
Specify the VLAN name to apply to the access rule.
VLAN ID
Specify the VLAN ID to apply to the access rule.
Click the <<Back button to discard the changes made and return to the previous page.
Click the Apply button to accept the changes made.
After clicking the Show Details button in the Egress Access Rule List, the following page will appear:
Figure 7-53 Egress Access Rule Detail Information window (Ethernet ACL)
Click the Show All Rules button to navigate back to the Access Rule List.
Adding an IPv4 Egress ACL Profile
The window shown below is the Add Egress ACL Profile window for IPv4. To use specific filtering masks in this
egress ACL profile, click the packet filtering mask field to highlight it red. This will add more filed to the mask.
After clicking the Add Egress ACL button, the following page will appear: