xStack® DGS-3620 Series Managed Switch Web UI Reference Guide
191
Figure 5-48 OSPFv3 Area Settings window
The fields that can be configured are described below:
Parameter Description
Area ID
Enter the OSPFv3 area’s ID. It is a 32-bit number in the form of an IPv4 address that
uniquely identifies the OSPFv3 area in the OSPFv3 domain.
Type
Specifies the OSPFv3 area mode of operation.
Normal – The OSPFv3 area will be created as a normal area.
Stub – The OSPFv3 area will be created as a stub area.
Stub Summary When Stub is selected in the Type drop-down menu, use the drop-down menu to
specify whether the OSPFv3 stub area imports inter-area prefix LSA advertisements or
not.
Metric (0-65535)
Enter the default cost of OSPFv3 stub area.
Click the Apply button to accept the changes made.
Click the
View Detail
Click the Edit button to re-configure the selected entry.
link to view a display of the OSPF Area settings.
Click the Delete button to remove the selected entry.
After click the
View Detail link, the following window will appear.
Figure 5-49 OSPFv3 Area Settings - View Detail window
This window is used to display the OSPF Area settings.
Click the <<Back button to return to the previous window.
OSPFv3 Interface Settings
This window is used to display the OSPFv3 configurations or OSPFv3 interfaces information.
To view the following window, click L3 Features > OSPF > OSPFv3 > OSPFv3 Interface Settings, as shown
below:
To Next Page
Loading...
