xStack® DGS-3620 Series Managed Switch Web UI Reference Guide
199
Figure 5-61 RIP Settings window
The fields that can be configured are described below:
Parameter Description
RIP State
Specifies that the RIP state will be enabled or disabled. If the state is disabled, then
RIP packets will not be either transmitted or received by the interface. The network
configured on this interface will not be in the RIP database.
Update Time (5-65535)
Enter the value of the rate at which RIP updates are sent.
Timeout Time (5-65535)
Enter the value of the time after which a RIP route is declared to be invalid.
Garbage Collection
Time (5-65535)
Enter the value of the time for which a RIP route will be kept before it is removed
from routing table.
Interface Name
Specifies the IP interface name used for this configuration.
Click the Apply button to accept the changes made for each individual section.
Click the Find button to find the specified entry.
Click the View All button to view all the entries.
Click the Edit button to re-configure the selected entry.
After clicking the Edit button, the following window will appear.
Figure 5-62 RIP Settings – Edit window
The fields that can be configured are described below:
Parameter Description
TX Mode Specifies the RIP transmission mode. Options to choose from are v1 Only, v1 Compatible
and v2 Only. Select Disable to disable this option.
To Next Page
Loading...
