xStack® DGS-3620 Series Managed Switch Web UI Reference Guide
256
Click the Delete button to remove the specific entry.
Click the
View Detail link to see the following window.
Figure 5-149 Route Map Settings - View Detail window
The fields that can be configured are described below:
Parameter Description
Sequence ID (1-
65535)
Enter the sequence number for the rule.
Direction
Use the drop-down menu to Permit or Deny the matched rule.
Click the Add button to add a new entry based on the information entered.
Click the <<Back button to return to the previous window.
Click the Delete All button to remove all the entries listed.
Click the Edit button under Match Clause or Set Clause to configure the clause.
Click the Delete button to remove the specific entry.
Click the Edit button under Match Clause to see the following window.
Figure 5-150 Route Map Settings - Match Clause window
The fields that can be configured are described below:
Parameter Description
Action
Use the drop-down menu to Add or Delete a sequence entry.
AS Path
Click the radio button and specify to match the AS path of the route against the AS path
list. The AS path list specified here needs to be a sub-list of the AS path list associated
with the route.
Community List
Click the radio button and specify to match the community of the route against the
community string. Tick the Exact check box to present all the specified communities.
IP Address List
Click the radio button and specify to match the route according to the access list.
To Next Page
Loading...
