D-Link DGS-3620-28PC-SI - Page 45

xStack® DGS-3620 Series Managed Switch Web UI Reference Guide
35
Parameter Description
IP MTU (512-1712)
Enter the IP Layer MTU value used. The value is between 512 and 1712. The default
value is 1500.
IP Directed Broadcast
Use the drop-down menu to enable or disable the IP directed-broadcast state of the
interface.
Get IP From
Use the drop-down menu to specify the method that this Interface uses to acquire an
IP address.
Interface Name
Enter the name of the IP interface being configured.
IPv4 Address
Enter the IPv4 address used.
Subnet Mask
Enter the IPv4 subnet mask used.
VLAN Name
Enter the VLAN Name used.
IPv4 State
Use the drop-down menu to enable or disable IPv4 State.
Interface Admin State
Use the drop-down menu to enable or disable the Interface Admin State.
Click the Apply button to accept the changes made for each individual section.
Click the <<Back button to discard the changes made and return to the previous page.
Click the IPv6 Edit button to see the following window.
Figure 3-11 IPv6 Interface Settings window
The fields that can be configured or displayed are described below:
Parameter Description
Interface Name
Display the IPv6 interface name.
IPv6 State
Use the drop-down menu to enable or disable IPv6 State.
Interface Admin State
Use the drop-down menu to enable or disable the Interface Admin State.
IPv6 Network Address
Enter the neighbor’s global or local link address.
DHCPv6 Client
Use the drop-down menu to enable or disable DHCPv6 client.
NS Retransmit Time
(0-4294967295)
Enter the Neighbor solicitation’s retransmit timer in millisecond here. It has the same
value as the RA retransmit time in the config ipv6 nd ra command. If this field is
configured, it will duplicate the entry into the RA field.