D-Link DIR-608 - L2 TP Connection Setup

31D-Link DIR-608 User Manual
Section 3 - Conguration
L2TP
Click L2TP on the navigation menu to congure L2TP (Layer 2 Tunneling Protocol) connection.
Your ISP will provide you with a server address, username, and password.
Session: Check the radio button to enable L2TP.
Name: Enter a name for your L2TP connection.
LNS IP: Enter the L2TP Server address.
LNS Port: Enter the L2TP Server port number.
Auth: Select PAP, CHAP, CHAPMSV2, or auto. The default is auto.
User Name: Enter the username provided by your ISP.
Password: Enter the password provided by your ISP.
Connection Type: Select either Continuous, Connect on Demand, or Manual.
Idle Time(min): If Connect on Demand is selected, enter a maximum idle time during
which the Internet connection is maintained during inactivity.
NAPT: Check the radio button to enable NAPT.
Default Route: Check the radio button to enable Default Route.
MTU: Enter the MTU size.
When you have nished conguring your L2TP Connection, click the Apply Changes button.
L2TP Settings
L2TP Settings
Session:
Disable Enable
Name:
LNS IP:
LNS PORT: 1701
Authentication:
auto
▼
User Name:
Password:
Connection Type: Continuous
▼
Idle Time(min): 0
NAPT:
Disable Enable
Default Route:
Disable Enable
MTU:
1460
L2TP
L2TP
DIR-608
Setup
Wireless
Apply Changes Reset