D-Link DIR-608 - Ipv6 in Ipv4 Tunnel

40D-Link DIR-608 User Manual
Section 3 - Conguration
IPv6 Connection Type:
Choose the mode to be used by the router to the IPv6
Internet.
My IPv6 Connection is:
IPv6 In IPv4 Tunnel
▼
IPv6 in IPv4 Tunnel Settings
Enter the IPv6 in IPv4 Tunnel information provided by
your Tunnel Broker.
Remote IPv4 Address:
Remote IPv6 Address:
Local IPv4 Address: 192.168.x.x
Local IPv6 Address:
/
My IPv6
Connection is:
Select IPv6 In IPv4 Tunnel if you wish to configure the IPv6
connection to run in IPv4 Tunnel mode. IPv6 over IPv4 tunnelling
encapsulates IPv6 packets in IPv4 packets so that IPv6 packets can
be sent over an IPv4 infrastructure.
IPv6 Connection Type
IPv6 In IPv4 Tunnel
Remote IPv4
Address:
Enter the IPv4 remote address you will use.
Remote IPv6
Address:
Enter the IPv6 remote address you will use.
Local IPv4
Address:
Displays the current local IPv4 address.
Local IPv6 Address
and Subnet Prefix
Length:
Enter the IPv6 local address and subnet prex length.
IPv6 in IPv4 Tunnel Settings
IPv6 DNS Settings
Obtain DNS server address automatically or enter a
specic DNS server address.
Primary DNS Address:
Secondary DNS Address:
If you choose Use the following DNS address, please congure the following eld:
Primary DNS
Address:
Enter the primary DNS server address.
Secondary DNS
Address:
Enter the secondary DNS server address.
IPv6 DNS Settings
Select either Obtain DNS server address automatically or Use the following DNS address.