D-Link DIR-608 - WPS Wireless Connection Setup

54D-Link DIR-608 User Manual
Section 3 - Conguration
WPS
WPS Setup
WPS
DIR-608
Wireless
Advanced
WPS Setup
WPS (WiFi Protected Setup), easily connect devices
to a wireless router.
To use the wizard to add a wireless client to WPS-enabled
wireless router, the client must support WPS.
Check the user manual or the box of the wireless client to
conrm whether it supports the WPS.
WEP If the wireless client does not support WPS, you must
congure it manually.
Next
The easiest way to connect your wireless devices to the router is with WPS (Wi-Fi Protected
Setup). WPS was introduced with two methods of connecting: Push Button Control (PBC)
and Personal Identication Number (PIN). Using WPS-PIN is no longer recommended due
to security vulnerabilities and is disabled by default. For more information refer to WPS
Button on page 88 for steps on using the WPS button to connect wireless clients.
Select
PIN Mode
If your card supports WPS,
pleace click “Generate PIN
code”, and input PIN Code
here.
Entry PIN of wireless NIC:
23474567
Applied client’s PIN successfully!
You have to run Wi-Fi Protected Setup in client within
2 minutes.
Back
WPS Setup
Click Next to begin the WPS Setup process.
Note: In order to use this page of the web conguration utility, you must enable WPS-PIN.
Refer to Advanced Wireless on page 55 for more information.
Select
Enter a WPS-PIN and click Start PIN to begin the WPS Setup pairing process. If successful,
you will then be taken to another screen and a message will tell you to run WPS on the client
device within 2 minutes.
Start PIN