D-Link DIR-608 - Wireless Security Setup

48D-Link DIR-608 User Manual
Section 3 - Conguration
Wireless Basics
Enable SSID
Broadcast:
Enable SSID broadcast if you want the router to transmit its SSID
publicly so other wireless devices can discover it.
Note: Disabling SSID broadcast is not a form of security alone.
Enable Wireless
Isolation:
Enable wireless isolation to prevent connected wireless devices from
connecting to other wireless devices that are also connected to the
router.
Name (SSID): Enter the SSID name of the router.
Mode: Use the dropdown menu to specify the wireless mode.
Channel: Use the dropdown menu to select the wireless channel.
Band Width: Use the dropdown menu to select the channel bandwidth. If you
selected the 802.11n, 802.11 b/g, or 802.11 b/g/n wireless modes,
the available options are 20 MHz and 20/40 MHz. For the others, 20
MHz is the only option.
Wireless Network
Click Wireless Basics on the navigation menu to congure your wireless LAN settings. You
can also congure the wireless security and wireless network parameters.
Wireless Network
Enable SSID Broadcast:
☑
Enable Wireless Isolation:
☑
Name(SSID) : D-Link_DIR-608
Mode :
802.11b/g/n
▼
Channel: Auto
▼
Current Channel: 2
Band Width:
Auto 20/40M
▼
Security Options
Select a wireless security encryption option. The options are None, WEP, WPA-PSK(TKIP),
WPA2-PSK(AES), and WPA-PSK/WPA2(AES). The following pages describe each type of
security option. Using WPA2-PSK(AES) security is recommended.
Security Options
Security Options :
WPA2-PSK(AES)
▼
Basic Wireless
Basic Wireless
DIR-608
Wireless
Advanced