D-Link DIR-608 - Page 45

41D-Link DIR-608 User Manual
Section 3 - Conguration
LAN IPv6 Address Settings
Use this section to congure the internal network settings of
your router. If you change the LAN IPv6 Address here, you
may need to adjust your PC’s network settings to access the
network again.
LAN IPv6 Address:
/64
LAN IPv6 Link-Local
Address:
xx00:yy11:zz22:123/64
IPv6 In IPv4 Tunnel (continue)
LAN IPv6 Address: Enter the LAN (local) IPv6 address for the router.
LAN IPv6 Link-
Local Address:
Displays the router’s LAN link-local address.
LAN IPv6 Address Settings
Enable
Autoconfiguation:
Enable or disable the Automatic IPv6 Address Assignment feature.
LAN IPv6 Address: Select SLAAC+Stateless DHCP or Stateful DHCPv6.
If you choose SLAAC+Stateless DHCP, please congure the following eld:
Router
Advertisement
Lifetime:
Enter the IPv6 address lifetime (in minutes).
Address Autoconfiguration Settings
If you choose Stateful DHCPv6, please congure the following eld:
IPv6 Address
Range(Start):
Enter the starting IPv6 address for the DHCP server’s IPv6 assignment.
IPv6 Address
Range(End):
Enter the ending IPv6 address for the DHCP server’s IPv6 assignment.
Router
Advertisement
Lifetime:
Enter the IPv6 address lifetime (in seconds).
Address Autoconguration Settings
Use this section to setup IPv6 Autoconguration to assign IP
addresses to the computers on your network.
Enable Autoconguration:
☑
LAN IPv6 Address: Stateful(DHCPv6)
▼
IPv6 Address Range(Start): xxxx ::00 3
IPv6 Address Range(End):
xxxx ::00 16
Router Advertisement
Lifetime:
(second)
Address Autoconguration Settings
Use this section to setup IPv6 Autoconguration to assign IP
addresses to the computers on your network.
Enable Autoconguration:
☑
LAN IPv6 Address: SLAAC+Stateless DHCP
▼
Router Advertisement
Lifetime:
30 (minutes)